Product ID:PRE-COTE PRIMER SEALER, 95-100
MSDS Date:10/23/1987
FSC:8010
NIIN:00N024843
MSDS Number: BMBGL

PRESERVATIVE PAINT CO

5410 AIRPORT WAY SOUTH
SEATTLE, WA 98108
US

Emergency Phone: 206-526-2121; 206-634-5252

Info Phone: 206-763-0300

Cage: 86589

PRESERVATIVE PAINT CO

80387 SEATTLE, WA 98108-1726 US

Cage: 86589

AMMONIUM HYDROXIDE

CAS: 1336-21-6

RTECS: BQ9625000

OSHA PEL 100 PPM (MFR)

ACGIH TLV: 100 PPM (MFR)

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

ETHYLENE GLYCOL

CAS: 107-21-1

RTECS: KW2975000

OSHA PEL 50 PPM, C

ACGIH TLV: 50 PPM VAPOR, C

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

SILICA (TYPE NOT SPECIFIED)

CAS: 68855-54-9

OSHA PEL 0.08 MG/M3 (MFR)

ACGIH TLV: 0.08 MG/M3 (MFR)

CALCIUM CARBONATE

CAS: 1317-65-3

RTECS: EV9580000

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

ALUMINUM SILICATE

CAS: 1318-74-7

OSHA PEL 10 MG/M3 TDUST (MFR)

ACGIH TLV: 10 MG/M3 TDUST (MFR)

SILICATE, MICA; (SILICEOUS MICA)

CAS: 12001-26-2

RTECS: VV8760000

OSHA PEL 20 MPPCF

ACGIH TLV: 3 MG/M3 RDUST; 9293

SILICON DIOXIDE, AMORPHOUS; (SILICA)

CAS: 7631-86-9

OSHA PEL 6 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

MERCURY, (ACETATO)PHENYL-; (PHENYLMERCURIC ACETATE)

CAS: 62-38-4

RTECS: OV6475000

OSHA PEL 0.05 MG/M3 (MFR)

ACGIH TLV: 0.05 MG/M3 (MFR)

EPA Report Quantity: 100 LBS

DOT Report Quantity: 100 LBS

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:MAY CAUSE IRRITATION OR BURNING
OF EYES. IF INGESTED MAY CAUSE GASTRO-INTESTINAL DISTRESS.
CHRONIC:REPEATED OR PROLONGED LIQUID CONTACT MAY CAUSE SKIN
IRRITATION W/DISCOMFORT & DERMATITIS. INHAL :NOT NORMALLY HAZARD
UNLESS SPRAYED, THEN OVERSPRAY & SPRAY MISTS ARE PRIMARILY
CONSIDERED NUISANCE (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:DUST. PIGMENTS ARE NOT NORMALLY
CONSIDERED HAZARDOUS WHEN PRESENT IN PRODUCT MIXTURE.
Medical Cond Aggravated by Exposure:PRE-EXISTING CONDITIONS INVOLVING
SKIN DISORDERS.

First Aid:INHAL:REMOVE TO FRESH AIR. IF NOT BRTHG, GIVE ARTF RESP, PREF
MOUTH-TO-MOUTH. IF BRTHG DFCLTY PERSISTS/OCCURS LATER, CALL MD.
EYE:IMMED FLUSH W/PLENTY OF H*2O FOR @ LST 15 MIN. CALL MD.
SKIN:WASH W/SO AP & H*2O. IF IRRIT OCCURS, CALL MD. INGEST:CALL MD
IMMEDIATELY.

Flash Point Method:TCC
Extinguishing Media:USE MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT . COOL CLOSED CONTAINERS W/WATER FOG TO
PREVENT PRESSURE BUILDUP.
Unusual Fire/Explosion Hazard:NONE REASONABLY FORESEEABLE.

Spill Release Procedures:VENTILATE AREA. PREVENT SKIN CONTACT &
BREATHING OF VAPOR. CONFINE & REMOVE W/INERT ABSORBANT MATERIALS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:OBSERVE LABEL PRECAUTIONS. KEEP
CLOSURES TIGHT WHEN NOT IN USE. STORE IN UPRIGHT POSITION TO
PREVENT LEAKAGE. DO NOT STORE ABOVE 120F.
Other Precautions:KEEP & STORE OUT OF REACH OF CHILDREN. DO NOT SAND,
FLAME CUT, BRAZE OR WELD DRY COATING W/OUT NIOSH/MSHA APPRVD
RESP/APPROP VENT. CNTNRS OF THIS MATL MAY BE HAZ WHEN EMPTIED.
SINCE EMPTY CNTNRS RETAI N RESIDUES, ALL HAZ PRECS MUST (SUPDAT)

Respiratory Protection:FOR BRUSH & ROLLER APPLICATION, RESPIRATORY
PROTECTION IS NOT NORMALLY REQUIRED. FOR SPRAY APPLICATION,
PROPERLY FITTED NIOSH/MSHA APPROVED VAPOR/PARTICULATE RESPIRATOR IS
RECOMMENDED.
Ventilation:LOC EXHST OR MECH (GENERAL) VENT SUFFICIENT IN PATTERN &
VOL TO KEEP VAPS BELOW APPLIC OSHA REQUIREMENTS.
Protective Gloves:SOLVENT IMPERVIOUS GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:COVERALLS ARE RECOMMENDED. SAFETY SHOWER &
EYE BATH.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING & BEFORE EATING
& SMOKING. WASH CONTAMINATED CLOTHING BEFORE REUSE.
Supplemental Safety and Health
OTHER PREC:BE OBSERVED. WHEN SPRAYING THIS MATERIAL KEEP SPRAY BOOTH
CLEAN. AVOID BUILDUP OF SPRAY DUST OR OVERSPRAY IN BOOTH OR DUCTS.

Boiling Pt:B.P. Text:212F,100C
Vapor Pres:23
Vapor Density:1.3
Spec Gravity:1.3
Evaporation Rate & Reference:0.2 (BUTYL ACETATE=1)
Solubility in Water:MODERATE
Appearance and Odor:MILKY WHITE & CLEAR TO VARIOUS COLORS W/FAINT
AMMONIA ODOR.
Percent Volatiles by Volume:73

Stability Indicator/Materials to Avoid:YES
NONE REASONABLY FORESEEABLE.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.

Waste Disposal Methods:DO NOT ALLOW MATERIAL TO CONTAMINATE GROUND
WATER SYSTEMS. ABSORB LARGE SPILLS W/INERT ABSORBANT MATERIAL.
INCINERATE OR DISPOSE ABSORBED MATERIAL I/A/W FEDERAL, STATE &
LOCAL REQUIREMENTS. DO NOT INC INERATE IN CLOSED CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.